013
Purchase an additional filter and alternate if necessary.
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note:
Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
Note:
C6-3—
C6-2—
Open the water tank and fill it with
clean water
.
Close the water tank and shake it
gently.
Pour out the remaining water as
shown.
Remove the VibraRise mop cloth from
the VibraRise mop bracket. Clean the
VibraRise mop cloth and air-dry it.
C7-1—
* Clean as required.
C8-1—
* Clean after each use and replace every 3-6 months.
Note:
A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Use a soft, dry cloth to wipe and clean all
sensors, including:
Use a soft dry cloth to wipe the charging
contacts on the robot.
C7-2—
C7-3—
Note:
If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
C12
Dustbin & Cyclone
Separator Cleaning
Notes:
•
To ensure optimal performance, clean the dustbin regularly
or when the dust reaches the MAX mark.
•
After using the cyclone separator, there may be a small
amount of debris such as hair or dust left in the dustbin.
This is normal and will not affect performance.
Notes:
•
To avoid potential corrosion, do not use detergents,
polishes or air fresheners to clean the dustbin or cyclone
separator.
•
Do not wash the dustbin or cyclone separator in a
dishwasher or washing machine.
Remove the dustbin vertically as
shown.
Empty the dustbin and remove the
cyclone separator.
Rinse the dustbin and cyclone
separator with cold water until
clean.
Leave the dustbin and cyclone
separator to dry for 24 hours or
until completely dry.
Rotate the cyclone separator as
shown to install it back in the
dustbin and close the bottom lid.
Reinstall the dustbin in the dock.
Hold the dustbin approx. 15 cm
(6 in) over a bin then press the
Dustbin Opener.
After emptying, close the bottom
lid and reinstall the dustbin on the
dock.
C11-1—
C12-1—
C12-2—
C12-3—
C12-4—
C12-5—
C11-2—
C11-3—
Open the filter cover and remove the
filter.
C6
Washable Filter
C9
Robot Sensors
C10
Charging Contact Areas
C11
Dustbin Emptying
C7
Water Tank
C8
VibraRise Mop Cloth
* Clean every 2 weeks and replace every 6-12 months.
* Clean monthly.
* Clean monthly.
* Clean as required.
* Clean monthly.
C6-1—
ReactiveAI Obstacle Recognition
Wall Sensor
Mop Wash Sensor
Carpet Sensor
Cliff Sensors
C9-1—
C9-2—
C9-3—
C9-4—
C9-5—
