Robomow MC150, Operating Manual

Page: 40 / 50

40
9.3
User Messages
The next table gives information about User Messages that can be displayed on the mower:
Display Message Probable Cause/Event Corrective Actions
0021
Check
mowing height
-Mowing motor has faced over-current
conditions for too long as a result of
high grass or an obstacle that is stuck or
wrapped around the blade.
-Something is preventing a blade from
rotating freely.
-Severe grass accumulation under the
mowing deck, rope, or similar object is
wrapped around mowing blade.
-CAUTION – Switch Off the Safety Switch
before checking the blade.
-Inspect the blade for foreign material or
debris preventing rotation.
-Clean out accumulated grass clippings
using a wooden stick.
0022
Check
mowing motor
-Mowing motor has faced over-current for
too long in the Base Station before starting
the operation.
-CAUTION – Switch Off the Safety Switch
before checking the blade.
-Remove the mower from the Base Station.
Inspect the blade for foreign material or
debris preventing rotation.
0023
Check power -See E4 in the above table
0026
Base problem -Robomow fails to enter the Base Station
several consecutive times.
-Adjust the Base Station position.
-Clean the contacts with a brush or piece of
cloth.
0027
Start
Elsewhere
-Drive wheel motors have been working
under severe load during automatic or
manual operation.
-Check to insure the mower is not stuck,
causing the drive wheels to slip.
-Check the ground around the mower for
holes or indentations. Fill with dirt and level
off.
-Check if the drive wheels are free to rotate
and nothing is blocking them.
-Remove the mower away from this
particular location and restart operation.
0028
Cross Outside
-The Perimeter Wire is too close to the
edge.
-The lawn slope is too big.
-Robomow does not succeed to turn in
place at the edge and it causes the mower
to slip out of the designated area.
-Robomow has slipped out of the Perimeter
Wire lope because of sloping area or wet
grass.
-Remove the wire towards the inner part of
the lawn.
-Do not include this area because of its
steep slopes.
-Fill holes and pits in the ground.
-Increase the cutting height.
0030
Start Inside
-Automatic operation is initiated while the
robot is placed out of the Perimeter Wire
loop.
-Place the mower inside the lawn and renew
the operation.
0031
Stuck in place -See E1 in the above table
0060
Check
Intensity
-The Intensity you have set is too high for
your lawn area.
-Decrease the Intensity you have set for the
zone(s) in your lawn.
0061
Decrease
Inactive Time
-See E8 in the above table
Display Message / Description Action Required
BATT
Recharge Battery. Low battery voltage. Recharge the Battery.
U001
Test Base Station position.
Displayed during the One-Time Setup.
Refer to section 5.2.4 in the User Manual.
U002
Peg Base Station.
Displayed during the One-Time Setup.
Refer to section 5.2.4 in the User Manual.
U003
Test wire position.
Displayed during the One-Time Setup.
Refer to section 5.2.5 in the User Manual
U004
Test wire ended (during the One-Time Setup)
Displayed only when using the Robomow App.
No action is required.
U018
Operation time is shorter than expected Battery run time is too short. Replace Battery.