Robland E2800, Manual

Page: 13 / 65

12
V0913 E 300 / E 2800
English Deutsch
Fig.8
Changing main sawblade and scorer
sawblade
(Fig.8-9-10)
Before changing sawblades always turn off the main switch (fig.6.1).
Handle saw blades with care, to avoid serious cuts and injuries.
The use off HSS saw blades is prohibited, use only carbide tipped saw blades.
The maximum diameter of the saw blades used on the machine is 315 mm.
Push the sliding table to the rear and open the saw cover (fig.8). Raise the main sawblade to its
highest position and put the key(3) into the saw arbor nut.
Put the locking pin (fig.9,2) in the opening of the sawtable and turn the arbor with the spanner untill
the locking pin (2) engages in the hole in the saw arbor pulley.
Now unlock the nut.Warning: the nut has a left thread, so loosen by turning the nut in the anticlockwise
direction. Before fitting the new sawblade ensure the blade and flanges are clean. This
prevents wobbling of the sawblade.
Never forget, after the saw arbor nut has been tightened, to remove the locking pin from the pulley
before starting up the motor.
The scorer saw blade is changed as follows : turn the scorer blade to the left and put the spanner
(fig.10,1) onto the flatened arbor. Loosen the bolt with the Allen
Fig.10 Fig.9