Then press and hold (D) for three (3) seconds – target hours will begin to flash. Advance
hours by pressing (A). Press (C). Minutes will appear flashing. Advance minutes by
pressing (A). Repeat this procedure for seconds and tenths. Exit the setting function at
any time by pressing (D).
You must turn “OFF” any targets you do not plan to use, rather than leaving the
setting at all zeros.
Turn the TARGET TIMER off (i.e. render it inactive) at any point in the setting sequence
by pressing (B). “OFF” will appear in the bottom row. Re-activate it by pressing (B)
again. If all targets are turned off, “ALL OFF” will appear in the bottom row.
Reset the TARGET TIME to all zeros during the setting sequence by pressing (A) and
(C) simultaneously. Setting function will remain active.
Target Chrono Operation:
Select desired target time by pressing (A). Refer to the
BAR GRAPH for target number. Using the above example, the first 1K time of 5:15.0 is
selected. Press (D) and (B) simultaneously to select either LAP time (interval from the
last reading) or SPLIT time (accumulated time of all readings) chronograph function for
the top row.
Start: Press (B) to begin timing. Upper row will display running time (LAP or SPLIT) in
1/100 second resolution.
Lower row will display TARGET TIME counting down in 1/10 second resolution. One
(1)
minute before the target time, a single beep will sound for your attention to the
upcoming target. If target time is less than one (1) minute, a single beep will sound when
activated.
When the target time arrives, a four (4) second alarm will sound. The lower row of the
display begins to count up in tenths (1/10) and the plus symbol (+) will appear below in
the box.
LAP/SPLIT: Press (A) to take a reading. A four (4) second alarm will sound and the lap
counter will increase by one (1). The display will freeze and show your actual time in the
top row and the difference from your target in the bottom row.
For example, this illustration shows an actual time of 5 minutes 19.78 seconds and the
difference (4.8 seconds, above) versus the target of 5:15.0.
Lap/Split Actual Time
Indicator
Time Difference Versus
Targel Time
