The TIMER mode operates as a reverse CHRONOGRAPH, counting down from a pre-
determined time to zero and sounding an alarm. Think of it as similar to a game timer on
the scoreboard which shows time left to play at a football, basketball, or hockey game or
a soccer match.
CAPABILITIES: You may input up to five (5) separate countdown times. Each time is
precise to 1/10 second up to 16 hours. The times may be structured to countdown a
single time, or programmed to operate sequentially in a “loop” pattern.
Select from three (3) separate timer functions. In all three (3) timer functions, the preset
time will countdown to zero (“00”), sound an alarm and:
CS: Countdown Stop. Stops automatically at conclusion of countdown times(s).
CR: Countdown Repeat. Automatically repeats countdown time(s).
CC: Countdown Chrono. Operates as a full function MULTI-MEMORY CHRONO upon
completion of countdown time(s).
Using the Countdown Timer:
Keep the following sequence in mind when setting and
using the timer.
1.
Select which function (CS, CR or CC) you require.
2.
Select from single time or “loop” sequence.
3.
Set in the preset time(s).
4.
Start, stop and re-start the timer as required.
Setting the Countdown Timer(s):
Upon entering the TIMER mode, refer to the symbol
in the box for the function displayed:
CS: Countdown Stop
CR: Countdown Repeat
CC: Countdown Chrono
The Bar Graph will indicate which of the five (5) preset times is displayed (1, 2, 3, 4 or
5). While the timer is stopped, (press (B) to stop an active time) select which preset time
is first to be set and used by pressing (A).
Selecting the Timer Function:
After selecting the first countdown time to be set, press
and hold (D) for three (3) seconds. TIMER function symbol (CS, CR or CC) in the box
will begin to flash. Select the timer function to be used by pressing (B).
Selecting Single Timer for Loop Sequence:
With the TIMER function symbol in box
flashing, press (A) to select from single or loop functions. When the “loop” timing is
active, the LOOP symbol (
4
) will appear. The LOOP symbol will disappear when single
timing is selected.
When the LOOP function is activated, (
4
) appears and the timer will automatically
sequence through and countdown all preset times. When the current countdown time is
