Robe redwash 3-192, User Manual

Page: 7 / 27

REDWash 3•192
7
If you wish to change the lens module, follow this procedure:
1. Switch the fixture off.
2. Shift the security lock (1) to the “open “ posititon (black mark).
3. Press and hold the lens module lock (2) on the side cover of the fixture head and gently lift the module (3)
upward at the side where this lock is pressed.
4. Press and hold the lens module lock (2) on the opposite side of the fixture head and gently lift the lens module
(3)
from its placing and remove it.
5. Fit the new lens module into the fixture head and gently push it downward until the module snaps in.
Make sure that the lens module locks (2) are properly locked.
6. Shift the security lock (1) to the “locked” position (red mark) to secure the lens module in the placing.
Ensure the security lock is in the “locked” position (RED mark) before starting the fixture operation .
t is possible to install a plastic film to the glass holder module in order to get frost light.
1. Uninstall the 25°lens ‐ array module (1) as described above.
2. Insert the plastic film (2) into the slots under partitions in the glass holder module.
3.
Install the glass holder module back to the fixture´s head as described above.
The shape (dimensions) of the plastic film depends on its thickness and elasticity. We advice to use 2 shapes of
plastic films:
Film thickness =< 0.5mm Film thickness > 0.5 mm
Maximum thickness of the film is 0.8mm.