22
you will wait for a service intervertion! If the lamp light sensor is switched Off,the error messages
"LAEr,SnEr,HEAt" will not appear on the display (only the message "HEAt" will appear if the lamp was turned off
and on within 5 minutes ) and at switching the lamp on the electronics will still try to ignite the lamp until it shines
(even when the lamp is damaged or absent), on this account some electronics parts could be damaged!
- Display adjusting
This function allows you to adjust the display settings:
- Display -intensity
With this function you can adjust the display intensity from 20% to 100% . Use the [Up ] or [Down
] buttons to select the level of the display intensity and press [Enter ] to confirm or [Mode ] to
cancel and return to the menu.
- Display-reverse
With this function, you can rotate the display by 180°. Use the [Up ] or [Down ] buttons to select
"normal display" or "display turned by 180°" and press [Enter ] to confirm or [Mode ] to cancel and
return to the menu.
- Display-On
This function allows you to keep the display on or to turn off automatically 2 minutes after last
pressing any button on the control panel. Use the [Up ] or [Down ] buttons to select "On" if you wish
to keep the display on or "Off" if you wish to turn off automatically 2 minutes after last pressing any
button on the control panel and press [Enter ] to confirm or [Mode ] to cancel and return to the
menu.
Summary of Contents for ECOLOR 250 XT
Page 1: ......
