DigitalSpot 3000 DT
20
4. Operating modes
Before operating the DigitalSpot 3000 DT from a DMX 512 controller, you need to define the source of DMX data,
which may be:
DMX 512
- data is transmitted over standard DMX cables. Set a valid DMX start address, which is defined as the
first channel from which the DigitalSpot 3000 DT will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each DigitalSpot 3000 DT correctly
and independently from any other fixture on the DMX data link.
For DMX start address setting, please refer to the instructions under "Fixture Address".
ArtNet
- data is transmitted over Ethernet network using Artnet protocol. Set an IP address, Artnet Universe and
Artnet Subnet.
For Artnet setting, please refer to the instructions under "Fixture Address".
15. Control menu
The control panel situated on the front panel of the base offers several features. You can simply set the fixture
addresses, configure the fixture, run test, make a reset and also use many functions for setting fixture
behaviour.
Control elements on the control board:
[RNS] encoder wheel-moves between menu items on the same level, scrolls between values.
[ESC] button-leaves menu without saving changes
[ENTER] button-enters menu, confirms adjusted values and leaves menu
After switching the fixture on,
than press [ENTER] and
the display shows the initial screen:
the display shows address:
The main menu of the control panel is accessed by pressing the [ENTER] button. To browse through the menu,
rotate the [RNS]
wheel. To select a function or submenu, press the [ENTER] button.
15.1 Fixture Address
Use this menu to set the DMX address.
DMX Setting
--- Select this submenu to set the DMX start address.
Set DMX Address -
sets DMX address. After selecting desired DMX address confirm setting
by using the function "Activate DMX Mode":
Activate DMX Mode
- Data is received from DMX input.
Artnet Setting
--- Select this submenu to set the fixture for Ethernet operating.
Set IP Address
- Select this submenu to set an IP address and NetMask.
The IP address is the Internet protocol address and uniquely identifies any node (fixture) on
a network. There can't be 2 fixtures with the same IP address on the network!
Default IP Address
-Preset IP address.
Custom IP Address
- The option enables edit all numbers of the IP address.
To set the custom IP address:
1. Select „Custom IP Address” and press the [ENTER].
2. Use RNS wheel to set the first number of the IP address
Summary of Contents for DigitalSpot 3000 DT
Page 1: ...Version 1 7 ...
