34
Caution:
The message is disabled if the lamp light sensor (function "Lamp Sensor"in menu Personality) is
switched Off.
Lamp Error
The ignition of the lamp is seven times unsuccessful (the "
Active Lamp Timer
" message appeared six times
before), and the display shows
"
Lamp Error
"
, meaning that the lamp could be damaged or even missed or there
could be a failure on the ignitor or ballast.
Please place or replace the lamp and contact your dealer if the situation was not caused by the lamp.
Caution:
The message is disabled if the lamp light sensor (function "Lamp Sensor" in menu Personality) is
switched off.
Lamp Sensor Error
This message informs the lamp light sensor is failed.
Caution:
The message is disabled if the lamp sensor (function Lamp Sensor in menu Personality) is switched Off.
Overheated-Lamp Off
This message informs that the fixture head is overheated and the lamp was switched off by its temperature sensor
Short Power Error
This message will appear if the fixture was shortly disconnect from the main.
Supply Frequency Error
This message will appear if the frequency of the main is not standard 50 or 60 Hz.This message can appear as
a result of the interference during the lamp starting (if the lamp or igniter is old) or as a result of the interference
by neighbouring devices.
In these cases the message does not affect the fixture operating!
Temper.Sensor Error
The message informs you that the communication betwen the head and the main board in the fixture base was
cut off (or the head temperature sensor is defective) and the lamp was automatically switched off.
The following error messages are separated into 2 groups:
xxxx xxxx Error 1
(e.g.
Colour Wheel 1 Error 1
)
xxxx xxxx Error 2
(e.g.Colour Wheel 1 Error 2 )
There are some possible reasons of faults:
Message
Characteristic fault
xxxx xxxx Error 1
Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the
PCB)
xxxx xxxx Error 1/xxxx xxxx Error 2
Magnetic sensor is permanently Off(e.g.leading wire is disconnected,
(together)
defective magnetic sensor,missing magnet),defective stepping motor
Colour Wheel 1 Error 1 (Colour Wheel 1 Error 2 )
The messsages will appear after the reset of the colour wheel if this wheel is not located in the default position.
Colour Wheel 2 Error 1 (Colour Wheel 2 Error 2 )
The messages will appear after the reset of the colour wheel if this wheel is not located in the default position.
Rot.Gobo Wheel Error 1 (Rot.Gobo Wheel Error 2 )
The messages will appear after the reset of the gobo wheel if this wheel is not located in the default position.
Rot. Gobo Index. Error 1 (Rot. Gobo Index. Error 2 )
The messages will appear after the reset of the gobo wheel 1 if the rotating gobo wheels are not located in the
default positions.
Static Gobo Error 1 (Static Gobo Error 2 )
The messages will appear after the reset of the gobo wheel if this wheel is not located in the default position.
Iris Error 1 (Iris Error 2)
The messages will appear after the reset of the iris if the iris lamellas are not located in the default positions.
Pan Error 1 (Pan Error 2)
The messages will appear after the reset of the yoke if the yoke is not located in the default position.
Summary of Contents for ColorSpot 575E AT
Page 1: ...1 Version 1 4 ...
Page 36: ...36 ...
