Robe ClubWash 500 CT, User Manual

Page: 22 / 27

10. Low power mode
This mode omits fixture reset after switching the fixture on and lowers motor powers of the fixture."Power down
mode" is useful in special cases e.g. if the fixture is in a flight case and you want to set its DMX address without
taking it out from the case.To enter "Power down mode",press and hold [UP] and [DOWN] and at the same time
switch on the Power switch.The following message appears on the display:
"P.d.Mo."
You can set features and behaviour of the fixture by using "
A001
"menu and
"Pers.
" menu.If you want to go to
the "normal operation mode",execute fixture reset.
Note:
All motors (except pan and tilt motors) in "Low power mode" are deactivated and switching on the lamp
from the control panel is blocked.
11. Error and information messages
HEAt
This message appears if you try to switch on the lamp within 5 minutes after having switched it off (the lamp is
too hot). The message will appear on the display if the lamp doesn’t ignite within 28 seconds. The ClubWash
500 CT will store this information and automatically ignite the lamp when the 5 minutes period has expired.
Caution: The message is disabled if the lamp light sensor (function “En.Sn.”) is switched off.
LA.Er.
The ignition of the lamp is seven times unsuccessful (the “ HEAt ” message appeared six times before), and the
display shows “ LA.Er ” , meaning that the lamp could be damaged or even missed, or there could be a failure
on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or contact your distributor if the situation was
not caused by the lamp.
Caution: The message is disabled if the lamp light sensor (function “En.Sn.”) is switched Off.
FAn
The message informs you that the fixture was overheating and switched off. This message will appear on the
display if the fan speed operating “LOOF” was selected.
MbEr
This messsage informs you that the main PCB does not communicate correctly with the Control Board.
FtEr
This error message informs you that the fixture was overheating (occured if the ambient temperature is 40° C
or more) and that the temperature sensor switched off the lamp. This message will appear on the display until
the temperature will be on a suitable level, then the display will show the “ HEAt ” message meaning the lamp
is too hot.
SnEr
This message appears if the lamp lighting sensor is failed.
Caution:
The message is disabled if the lamp light sensor (function “En.Sn.”) is switched Off.
PoEr
This message will appear if the fixture was shortly disconnect from the main.
PAEr (PAN movement error)
This message will appear after the reset of the fixture if the yoke’s magnetic-indexing circuits malfunction (sen -
sors failed or magnet missing) or the stepping motor is defective. (Or its driving IC on the main PCB). The yoke
is not located in the default position after the reset.
tiEr (TILT movement error)
This message will appear after the reset of the fixture if the head’s magnetic-indexing circuit malfunc -
tions (sensor failed or magnet missing) or the stepping motor is defective. (Or its driving IC on the main PCB).
The head is not located in the default position after the reset.
Fr.Er.
This message will appear if the frequency of the main is not standard 50 or 60 Hz.This message can
appear as a result of the interference during the lamp starting (if the lamp or igniter is old) or as a result of the
interference by neighbouring devices. In these cases the message does not affect the fixture operating!