9
Important:
The option „Off” is for „emergency operation” only if the lamp light sensor is defective and you will
wait for a service intervertion! If the lamp light sensor is switched off and at switching the lamp on the electronics
will still try to ignite the lamp until it shines (even when the lamp is damaged or absent), on this account some
electronics parts could be damaged!
DiSP.
-
Display adjusting
. This function allows you to change the display settings.
turn
- Select this function to turn the display by 180°.
d.On
- This function allows you to keep the display on or to turn off automatically minutes after last
pressing any button on the control panel.
d.Int.
- Select this function to adjust the display intensity (20-min.,100-max.).
bL.Co.
-
Blackout during movement correction
. Select this function to enable the blackout during the head
movemen
t correction (if the moving head lost its right pan/tilt position for a short moment).
FEEd
-
Pan/Tilt feedback
.This function allows to return the mowing head to the required pan/tilt position after
changing the position by external force (e.g.by stroke).
Be careful, the Pan/Tilt Feedback OFF is not the standard operation and the head of the fixture can be
demaged!
Note:
If the feedback was switched off, the pan/tilt-position is changed by an external force and the feedback
is switched on again, the moving head might not to be synchronized with the DMX signal. You have to make a
reset in order to synchronize the moving head with the DMX signal.
Fan.S.
-
Fan speed operating modes
. By using this function you can choose 5 types of the fan speed operating
modes.
Auto
- The fans automatically raise their speed in order to control inside temperature of the head, if the
temperature inside increases about certain level (the low fan speed reduces the cooling of the lighting).
This cycle can repeat several times until the temperature inside is on a suitable level.
HIGH
- The cooling fans work on max. speed (max. cooling). This mode we recommend for high ambient
temperature (30°C and more).
rEG
- This mode is the same as a
Auto
but the the bottom level of fans speed can be adjusted by DMX
(channel 6)
LoOF
- The fans keep the adjusted low speed until the temperature exceeds max. inside temperature
of the fixture, then the ClubSpot 500 CT automatically switches off the lamp.
LoHi
- The fans keep the adjusted low speed until the temperature exceeds max. inside temperature of
the fixture, then the ClubSpot 500 CT automatically switches from low to high the fan speed.
dF.SE.
-
Default Settings
. Select this option to reset all fixture personalities to the default values.
9.5 Lamp On/Off
Use this option in order to switch on/off the lamp.It is also important to note, that the lamp is cold restrike type,
that means, that it has to be cold before striking.
9.6 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using ClubWash 500 CT.
Mod1
--- Mode . This mode is suitable for projections on the wall, ceiling or ground
without any head movement.
Mod 2
--- Mode
.
This mode uses all ClubWash 500 CT functions including pan/tilt
movement and therefore is good for a complete introduction of the fixture.
Summary of Contents for ClubWash 500 CT
Page 1: ... Version 1 0 ...
Page 27: ...27 ...
