6
4. Installation
4.1Fitting the lamp
DANGER !
Install the lamps with the device switched off only.
Unplug from mains before !
To insert the lamp loosen the lamp cover at the rear of head (see the drawings ) by remowing the 3 fastening
screws which are marked
"X,Y,Z"
.Carefully pull out the cover with the lamp socket assembly.If changing the
lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not de-
signed for.Damages caused by non-observance are not subject to warranty. Please follow the lamp manu-
facturer‘s notes!Do not touch the glass-bulb with bare hands during the installation! Make sure that the lamp
is installed tightly into the lampholder system.
Reclose the lamp cover and tighten the 3 screws.
Before striking the lamp, reset the
"LAti"
and
"LASt"
counter s in the menu of the Control Board, by pressing
the
"Up"
and
"Down"
buttons in one time and then confirming with the
Enter
-button.
Do not operate this fixture with opened housing-cover!
3 fastening screws X,Y,Z
3 adjusting screws A,B,C
lamp cover
4.2 Lamp adjustment
The ClubWash 500 CT lamp holder is aligned at the factory. Due to differences between lamps, fine adjustment
may improve light performance.
Strike the lamp,open the shutter and set the dimmer intensity onto 100% and aim the light at a flat surface
(wall).Center a hot-spot(the brightest part of the image) by using the 3 adjustment screws "
A,B,C
".Turn one
screw after another a quarter-turn clokwise(counter-clokwise) to set the hot-spot in the center of the image.If
you cannot detect the hot-spot,adjust the lamp until the light is evenly distributed.
Summary of Contents for ClubWash 500 CT
Page 1: ... Version 1 0 ...
Page 27: ...27 ...
