8
rSEt
--- The function shows the number of the operation hours with the lamp on that the
ClubWash 500 CT has been powered on since the counter was last reset.In order to
reset this counter to 0 you have to hold [UP] and[DOWN ] and press the [ENTER].
LA.St.
---
Lamp strikes
.Select this submenu to read the total number of the lamp strikes.
totL
--- The function shows the total number of the lamp strikes since the ClubWash 500 CT
has been fabricated.
rSEt
--- The function shows the number of the lamp strikes since the counter was last
reset.In order to reset this counter to 0 you have to hold [UP] and[DOWN ] and press
[ENTER].
Hi.tE
---
Max.fixture head temperature
.Select this submenu to read the max. fixture head temperatures
(°C).
totL
- The function shows the max.temperature of the head inside since
the ClubWash 500 CT has been fabricated.
rSEt
- The function shows the maximum temperature of the head inside
since the counter was last reset.In order to reset the counter to 0 you have
to hold [UP] and[DOWN ] and press the [ENTER].
tEMP
---
Current head temperature
.Select this submenu to read the current fixture head temperature (°C).
Temperatures below 78°C are not critical. 78° C and more lead to the lamp being switched off.Please note
that the outside temperature should not exceed 40° C.
DM.In.
---
Readout of DMX values
.Select this function to read DMX values (0-255) of each channel received
by the fixture.
PAn
a coarse pan movement
MAGE.
a magenta lemellas
F.PAn
a fine pan movement
YELL.
a yellow lamellas
tilt
a coarse tilt movement
Macr.
a CMY macros
F.tilt
a fine tilt movement
C.SPd.
a CMY/dimmer speed
SpEd
a pan/tilt speed
Stro.
a strobe,shutter
Func.
special functions
dimr
a shutter,strobe
CYAN
a cyan lamellas
VErS.
-
Software version
. Select this function to read the software version of processors:
IC1.b.
- Main processor on the main board in the fixture base
IC2.b.
- Pan processor on the main board in the fixture base
IC3.b.
- Tilt procesor on the main board in the fixture base
IC1.r.
- Processor 1 in the right arm of the fixture
IC2.r.
- Processor 2 in the right arm of the fixture
9.4 Personality
Use this menu to to modify ClubWash 500 CT operating behavior.
16br.
-
16 bit resolution
. Select this function to set desired effects assigning to the channels. Please refer to
the chapter „DMX protocol” for detail description.
LA.Pr.
-
Lamp presetting
. Select this menu to change the lamp „behaviour”.
LA.Au.
- Select this function to turn the lamp on automatically after switching the fixture on.
d.L.OF.
- Select this function to switch off the lamp via DMX.
dM.On
- This function allows you to strike the lamp automatically after 6 seconds if DMX signal is
present on the data link. If the ignition is unsuccessfull (e.g.lamp is too hot), the fixture will try to ignite
the lamp after next 26 s.This process will repeat until the lamp lights.
dM.OF.
- This function allows you to switch Off the lamp automatically after minutes if DMX signal
is missing on the data link.
En.Sn.
-
Switching on/of the lamp light sensor
. Select this function to switch the lamp light sensor on or
off.The option „On” is for the standard operation.
Summary of Contents for ClubWash 500 CT
Page 1: ... Version 1 0 ...
Page 27: ...27 ...
