CitySkape Xtreme (RGBW)
7
3.3 Installation of the barn-doors, top/half top hats
You can install barn-doors or top hats to better define illuminated surface.
Before installing the equipment disconnect the fixture from the mains.
1.
Fit the barn-doors module (1) or top/half top hat (2) on the LED module (4) and fasten it by means of the
12 screws (3) as shown on the picture below.
2.
Repeat the same steps for the second LED module of the fixture.
Never close the barn-doors during fixture operation!
3.4 Changing the beam angle
If you need to get a wide beam angle (25°), you have to install frost glasses to both LED modules.
Before installing the frost glasses disconnect the fixture from the mains.
1.
Unscrew the ten countersunk screws (1) from the LED module (3).
2.
Lift the frame (2) with the gasket strip and carefully remove the clear glass (5) from its placing.
Place the frost glass insted of the clear one.
3.
Place the frame (2) with the gasket strip back on the LED module (3) and screw it with ten screws (1).
4.
Repeat the same steps for the second LED module of the fixture.
Summary of Contents for CitySkape Xtreme
Page 1: ...Version 2 2 ...
