Robe CitySkape Xtreme, User Manual

Page: 16 / 24

CitySkape Xtreme (RGBW)
16
Note: The ambient temperature should not exceed 40°C.
Measuring points:
LEdS .--- the temperature of the LEDs module.
boAr. --- the temperature on the PCB in the fixture head.
The temperatures can be displayed in either °C or °F units - see option “tEM.U“ in the menu “Pers“.
VErS. --- Software Versions. Select this function to read the software versions of the fixture processors.
IC1 --- the processor controls LED modules
IC2 --- EEprom
6.3 Personality
Use this menu to modify the CitySkape Xtreme operating behaviour.
DM.Pr.
---
DMX preset
. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
DiSP. --- Display adjusting . This function allows you to change the display settings.
d.On --- this function allows you to keep the display on or to turn off automatically 2 minutes
after last pressing any button on the control panel.
d.Int. --- select this function to adjust the display intensity (20-min.,100-max.).
turn --- select this function to turn the display by 180°.
tEM.U. --- Temperature Unit. Use this menu in order to display the fixture temperatures in desired units: °C or °F.
bALA --- Balance Use this menu item to enable (On) or disable (Off) the white balance which is set in the “White
colour balance“ menu below. I f this function is set off, the CitySkape Xtreme will use maximum values (255) of
saturation for red, green and blue colour. This function has to be set on before adjusting a white balance.
C.bAL. --- White Colour Balance. The menu gives access to the setting of the white balance.
To set the white colour balance.
1. Use a DMX controller or the “ Man.C.“ menu to set all LEDs on max. saturation.
2. Use the UP/DOWN buttons to find the “ Pers.“ menu.
3. Press the ENTER button.
4. Use the UP/DOWN buttons to select the “C.bAL“menu.
5. Press the ENTER button and the “rEd“ item will appear on the display.
6. Press the ENTER button and use the UP/DOWN buttons to set new max. value for the red LEDs.
7. Press the ENTER button to confirm the choice.
8. Use the UP/DOWN buttons to select next colour, the “GrEn“.
9. Repeat steps 6-7 for this channel.
10. Use the UP/DOWN buttons to select the last colour, the „bLuE“ and repeat steps 6-7 for this colour.
LoAd --- Load of LEDs . The menu allows to choose 2 different operating modes for fixture´s LEDs.
FuLL --- Maximum light output.
EcO. --- The light output is decreased by 25%.
In.Po.
--- Init effect positions. Use this function to set all effects to the desired positions to which they will move
after switching the fixture on (if DMX is not being received).
Note. If DMX mode 1 is selected, only values set at items “MACr” (macro) and dinr (dimmer) will be accepted.
dF.SE.
---
Default Settings .
The menu item sets all fixture parameters to the default (factory) values.