Gas Safety(Installation and Use)Regulations
IMPORTANT
:
The appliance must
be
connected
to
the
gas
supply
by
use
of
a
15
mm
x 1/2
＂
conical
thread
female.coupler
,
seal
,
copper
pipe
and
an
isolation
tap
fitted
in
an
easily
accessible
position.
◆
It is the law that all gas appliance are installed by competent persons in accordance with the current
edition of the gas safety installation and use regulations.
◆
It is in your interest and that of safety to ensure compliance with the law.
◆
An AUTHORISED PERSON work to safe standards of practice. The hob must also be installed in
accordance with the current edition of AS/NZS 5601.1 Failure to install the cooker correctly could invalidate
the warranty, liability claims and lead to prosecution.
6
Gas
Hob
Inlet
connection
region
for
flexible
hose
800
250
50
250
Width
of
appllance
Gas connection
◆
Flexibility hose connection
The flexibility hose must be certified to AS/NZS1869 - class B or class D.The inner Ø must be
10
mm and the maximum length
1.2
m(The gas connection has a Rp 1/2
＂
conical
thread
)
.
Any hose assembly
used must be restrained from accidental contact with the flue outlet of an under bench
oven
.
This
hose
assembly
shall
be
suitable
for
connection
to
a
fixed
consumer
piping
outlet
located
as
follows
:
Hotplates at a point 800 mm to 850 mm above the floor and in the region outside the
width of the appli
ance to a distance of 250 mm
.
◆
The supply connection point shall be accessible with the appliance installed.
◆
The walls behind and near the hob should be resistant to heat, steam and condensation.
◆
Remember that the quantity of air necessary for combustion must never be less than 2m³/h for each kW of
power (see total power in kW on the appliance rating plate).
Note
:
Injector or cone end fittings dependant on the national situations in countries of destination.
Note
:
Cylinder
,
regulator
type
,
gas
type
and
gas
pressure
dependant
on
the
national
situations
in
countries of destination.
▶
THIS
CURRENT VERSIONS OF THE FOLLOWING.
▶
HOSE
ASSEMBLY
MUST
BE
RESTRAINED
TO
PREVENT
ACCIDENTAL CONTACT
WITH
THE
FLUE
OF
AN
UNDERBENCH
OVEN
.
APPLIANCE MUST BE INSTALLED BY A COMPETENT PERSON IN ACCORDANCE WITH THE
