PROPELLER
NOTE: Refer to the propeller manufacturer’s manual for instal-
lation, removal, and further detailed information.
The propeller shipped with your boat is the size Robalo recom-
mends for the best overall performance. However, factors such as
altitude, temperature, load, bottom growth, and propeller condition
can affect your boat’s performance. Consult your Robalo dealer
regarding your specific performance requirements.
Periodically check propeller for excessive wear and damage. Repair
or replace, if required.
Steering System
Your boat has a hydraulic steering system, it needs periodic mainte-
nance to be trouble free and safe. Regular checks of the complete
system are essential.
Lubricate, inspect, and maintain system regularly.
1. Rinse off your steering cylinder thoroughly with fresh, clean
water after each use.
2. Remove, clean and grease the support rod annually with quality
marine grease.
3. Check the steering fluid level in the helm.
4. Replace any hoses showing signs of wear and remove the
cause or re-route hoses.
5. Check fittings and seal locations for leaks, damage, and service
as necessary
Consult your Robalo dealer regarding all repairs or replace-
ment parts.
BILGE
Inspection
Check the bilge before you use your boat—every time! A small
amount of water in the bilge is normal and not a cause for concern.
If the amount of water is excessive, check for water leaks. Repair
leaks immediately.
If the bilge is ever filled with fuel or oil, check engine, hoses, fuel
tank(s), etc. for leaks. Repair immediately.
Important: Pumping fuel or oil overboard into the water vio-
lates the Federal Clean Water Act. Pump into suitable container
and dispose of properly.
Cleaning
Run bilge until pump is dry. Remove all sand, silt, dirt, or foreign
material. Make sure all limber holes are open and strainers are
clean. Use bilge cleaner to remove any obvious oil stains.
Important: Never use any flammable solvents for cleaning
the bilge. Check with your Robalo dealer for recommended
cleaners.
6-3
WARNING:
Gasoline or vapors in bilge can explode. Remove
all sources of ignition. Do not start engine, repair immediately.
Summary of Contents for 2012 220
