RoadHog RH3075, Manual

Page: 7 / 50

7
READ THIS ENTIRE MANUAL AS
WELL AS THE DECALS ON THE
ATTACHMENT BEFORE ATTEMPT-
ING ANY MAINTENANCE, SERVICE
OR SETUP OF THE UNIT.
SETUP
Hoses / Fittings
Hydraulic fittings are used to connect
all hoses. All fittings should be tight
and free of hydraulic leaks. Hoses
must be free of crimps or cuts that
might result in leakage. Check your
attachment before operation to make
sure all hose routings are kink-free and
allow for maximum movement of all
depth and sideshift functions required
during normal operation.
Wire Harness
The wiring harnesses should be routed
to prevent catching or pinching when
sideshifting or lowering the drum fully
into the cut.
Drum Assembly
For proper operation, teeth must be
installed in every holder on the drum.
Welds on holder and blocks should
be inspected weekly for cracks. Any
cracks should be fixed as soon as pos-
sible. Teeth should be inspected daily
for wear. Tooth should be allowed to
freely rotate within their holders.
Holders should be inspected daily for
wear. Holder wear is not typically cov-
ered under warranty. Holders may be
hardfaced to replace worn holder ma-
terial.
WARNING
Although the Roadhog Inc is supplied
fully assembled, some simple checks
should be performed before operation
begins.
Safety Decals
The safety decals existing on the attach-
ment should be clearly readable and al-
ways followed. The location and descrip-
tion of the decals is shown in the ex-
ploded diagram. Copies of the decals are
shown in
“Safety Decals” section.
Lubrication
The deadshaft bearing, supporting the
right hand side of the drum, should be
lubricated at least once a week. Daily
lubrication may be required during heavy
use or in extremely dusty conditions.
The planetary oil should be changed af-
ter the first 50 hours of operation, and
then once a year after that.