RoadHog RH3075, Manual, Page: 10 / 50

10
STARTING PROCEDURE- USING MASTER PANEL ON ROADHOG
This procedure requires another operator at ground level.
Engine start
1. Follow all safety procedures
2. Press red power button on LCD display on master panel
3. Place “radio/panel” switch on master panel switch in “ panel” position
4. Turn and pull red shutdown button out on master panel
5. Press “engine start” button on master panel until engine starts
Drum drive engagement
1. Follow all safety procedures
2. Allow engine to reach normal operating temperature
3. Switch “ engine throttle” switch on master panel up for 2 seconds to engage high idle
4. Engage and hold “ clutch engage “ switch up on master panel for 4 to 8 seconds
NOTE: momentary delay of engagement is normal
This engagement may take longer in cooler temperatures.
Drum depth engagement
1. Press and hold “depth” switch on master panel down lower the cutting drum
until the desired cutting depth is reached. Press the “depth” switch on master
panel up to raise the cutting drum.
Sideshift engagement
1. Press and hold “sideshift” switch on master panel. Hold until desired position is reached.
2. Release switch
Tilt engagement IMPORTANT: Always preset the desired angle and depth of cut
prior to making the cut.
1. Press and hold the “tilt” switch until the desired angle is reached.
2. Press and hold the “ depth” switch until the desired depth of cut is reached.
3. Lower the drum into the cut by lowering the loader arms. Only one ski will contact the ground.
Normal shutdown procedure using master panel ( non-emergency only )
1. Press “ clutch disengage” switch down to disengage clutch and drum
2. Switch “ engine throttle” switch on master panel down to engage low idle
3. Press “shutdown” button on master panel to stop engine
WARNING
If an emergency arises, immediately apply the wheel loader’s brakes and
stop the wheel loader’s engine and the Roadhog’s engine.
The Roadhog’s engine may be stopped by pushing the red shutdown
button on the master panel or by pushing the red emergency stop button
on the remote transmitter.