RoadHog RH3075, Manual

Page: 12 / 50

12
STARTING AND OPERATING PROCEDURE - USING REMOTE TRANSMITTER
This procedure may be done at ground level using an additional operator, or may
be done by a single operator from the wheel loader’s operator seat.
Engine start
1. Follow all safety procedures
2. Press red power button on LCD display on master panel
3. Place master panel switch in “ radio” position
4. Turn remote key on.
5. Pull out red emergency stop button “out” on remote transmitter
6. Check for green power indicator light on remote transmitter
7. Turn and pull red stop button “out” on master panel
8. Press “fuel run/stop” button on remote transmitter once
9. Press “engine start “ button on remote transmitter until engine starts
Drum drive engagement
1. Follow all safety procedures
2. Allow engine to reach normal operating temperature
3. Press “throttle high/low” button on remote transmitter once to engage high idle
4. Press “ clutch engage” button on remote transmitter for 4 to 8 seconds to engage drum
NOTE: Momentary delay of engagement is normal. This engagement may take longer in cooler
temperatures.
Drum depth engagement
1. Press and hold drum down arrow button on remote transmitter to lower the cutting drum until the
desired cutting depth is reached. Use the drum up arrow button on remote transmitter to raise the
cutting drum.
Sideshift engagement
1. Press and hold sideshift button on remote transmitter. Hold
until desired position is reached. Release button
Tilt engagement IMPORTANT: Always preset the desired angle and depth of cut
prior to making the cut.
1. Press and hold the “tilt” button until the desired angle is reached.
2. Press and hold the “ depth” button until the desired depth of cut is reached.
2. Lower the drum into the cut by lowering the loader arms. Only one ski will contact the ground.
Normal shutdown procedure using remote ( non- emergency only )
1. Press “ clutch disengage” button to disengage clutch and drum
2. Press “ throttle high/low” button to engage low idle
3. Press “ fuel run/stop” button to shut off fuel flow
WARNING
If an emergency arises, immediately apply the wheel loader’s brakes and
stop the wheel loader’s engine and the Roadhog’s engine.
The Roadhog’s engine may be stopped by pushing the red shutdown
button on the master panel or by pushing the red emergency stop button
on the remote transmitter.