RME Audio Hammerfall HDSPe AES, User Manual

Page: 65 / 72

User's Guide HDSPe AES
© RME
65
29.3 Digital
•
Clocks: Internal, AES/EBU In, Word Clock In, optional Video and LTC In
•
Low jitter design: < 1 ns in PLL mode, all inputs
•
Internal clock: 800 ps jitter, random spread spectrum
•
Jitter suppression of external clocks: about 30 dB (2.4 kHz)
•
Input PLL ensures zero dropout, even at more than 100 ns jitter
•
Supported sample rates: 28 kHz up to 204 kHz
29.4 MIDI
•
2 x MIDI I/O via breakout cable
•
PCI bus based hi-speed operation
•
Separate 128 byte FIFO for input and output
•
MIDI state machine in hardware for reduced interrupt request load
30. Technical Background
30.1 AES/EBU - SPDIF
The most important electrical properties of 'AES' and 'SPDIF' can be seen in the table below.
AES/EBU is the professional balanced connection using XLR plugs. The standard is being set
by the
Audio Engineering Society based on the AES3-1992. For the 'home user', SONY and
Philips have omitted the balanced connection and use either phono plugs or optical cables
(TOSLINK). The format called S/P-DIF (SONY/Philips Digital Interface) is described by IEC
60958.
Type AES3-1992 IEC 60958
Connection XLR RCA / Optical
Mode Balanced Un-balanced
Impedance 110 Ohm 75 Ohm
Level 0.2 V up to 5 Vss 0.2 V up to 0.5 Vss
Clock accuracy not specified
I:
±
50ppm
II: 0,1%
III: Variable Pitch
Jitter < 0.025 UI (4.4 ns @ 44.1 kHz) not specified
Besides the electrical differences, both formats also have a slightly different setup. The two
formats are compatible in principle, because the audio information is stored in the same place in
the data stream. However, there are blocks of additional information, which are different for both
standards. In the table, the meaning of the first byte (#0) is shown for both formats. The first bit
already determines whether the following bits should be read as Professional or Consumer
information.
Byte Mode Bit 0 1 2 3 4 5 6 7
0 Pro P/C Audio? Emphasis Locked Sample Freq.
0 Con P/C Audio? Copy Emphasis Mode
It becomes obvious that the meaning of the following bits differs quite substantially between the
two formats. If a device like a common DAT recorder only has an SPDIF input, it usually under-
stands only this format. In most cases, it will switch off when being fed Professional-coded data.
The table shows that a Professional-coded signal would lead to malfunctions for copy prohibi-
tion and emphasis, if being read as Consumer-coded data.
Nowadays many devices with SPDIF input can handle Professional subcode. Devices with
AES3 input almost always accept Consumer SPDIF (passive cable adapter necessary).