In order to lock the device, proceed with the following steps:
1. Open the
lock
tab in the
STATE
section (
see Use of the Display and Encoder
).
2.
(optional)
Set Code:
enter a four to six digit code with the encoder.
3.
(optional)
Activate the
Auto Lock
toggle to lock after one minute.
4.
(optional)
Select
Lock Device Now
to lock immediately.
Remember or write down the code shown in
SET CODE
. It is not possible to unlock the
device without this code. A unique secondary code (PUK) can be obtained from RME
Support upon request with a proof of purchase and device serial number.
To delete the code,
move the cursor on the code and push the encoder. "No code" will be displayed.
8.2.2. Unlocking the Device
To unlock the device
temporarily
:
1. Push and hold the encoder button for four seconds.
2. (if a code was set) Enter the code using the encoder and choose "Done".
The device will lock again after a timeout of one minute.
To unlock the device
permanently:
1. Proceed as above, then
2. Open the
lock
tab in the
STATE
section
3. Deactivate the lock by toggling the switch to:
OFF
4.
(optional)
Move the encoder onto the lock code (if any), and push the encoder to delete it.
8.3. Front Panel Illumination
The AVB Tool front panel illumination reveals the current device state at a glance. It combines:
• full color LEDs at each input
• a standby indicator with integrated status warning
• a display with level meters and status feedback
Each of these three elements can be individually switched off (
dark mode
).
RME AVB Tool User’s Guide
31
| 8.3. Front Panel Illumination
Summary of Contents for AVB Tool
Page 2: ...RME AVB Tool User s Guide...
