NOTE:
Introduce the complete Tail Assembly into the Tail Boom Holder as shown
in the diagram, Next .The Tail Rotor is pointing upwards. place the tail belt
on the Front Pulley and check the Tail Belt is not twisted.
Pull back and turn the complete Tail Assembly 90º clockwise and tighten
slightly the four M3x40 Socket Head Bolts and the M3 Locknut.Apply
Threadlock to the four M3x10 Bolts with the Finish caps.
Belt tension should be set so that
when pressing with you finger,the
sides of the belt do not come in
contact with each other. If unsure
is always better to set the belt
tension too tight rather than too
loose.Tighten up the M3x40 after
adjusting the tension.
Front Pulley
Tail Shaft
ROTATE THE DRIVE BELT
IN THE DIRECTION AS SHOWN.
Check that the tail rotor
is at 90 .
º
STEP 5-10 TAIL BOOM INSTALATION (Belt Version)
A26
M3x40 Socket Head Bolt
Loosen this screws
to attache the Belt
Loosen this screws
to attache the Belt
M3 Lock Nuts
