RJG Lynx ID7-M-SEQ, Product Manual

Page: 16 / 26

Lynx™ Shielded Sequence Module ID7‑M‑SEQ | Product Manual 10 RJG, Inc.
NOTE The following required signals may be
obtained from a machine output card.
Confirm the machine’s sequence output card
can supply a reliable 24 V signal. Input for all
signals 24 V ON; 0 V OFF. Maximum Input
Voltage 36 V; Minimum Trigger‑On Voltage
18 V. Wire the machine sequence signals to the
module cable C‑ID7‑M‑3M.
NOTE Note the signals which are wired to the
machine for future software setup and use.
The C‑ID7‑M‑3M cable has colored‑coded
wires to simplify installation. Refer to the table
below for the correct wire/signal combinations
for installation.
SIGNAL WIRING COLOR
Injection
Forward
IF Blue
First Stage 1ST Blue or Pink
Second Stage
any
unused
any unused
Screw Run SR Red
Mold
Clamped
MC Brown
Mold
Opening
MO Yellow
Mold Closing
any
unused
any unused
Manual Mode MAN White
Shuttle
Position
SHTL Green
INSTALLATION SPECIFICATIONS ( continued )
CONNECTIONS
Connect the C‑ID7‑M‑3M cable to the
ID7‑M‑SEQ module. Connect the ID7‑M‑SEQ
to the JLX‑1 junction using the CE‑LX5‑2M
Lynx cable.
C‑ID7‑M‑3M CABLE WIRING