Rivet King RK-4500, Instruction Manual

Page: 9 / 30

9
M
AINTENANCE
In order to maintain the tool in a safe working order it is important to carry out regular maintenance as
prescribed by the manufacturer. A thorough inspection replacement of all seals within the tool should be
carried out after 500,000 placings or annually, whichever is the sooner. Item numbers in parentheses
refer to assembly drawing part numbers
Daily Maintenance

Check for air leaks. Any damaged hoses should be replaced

Lubricate the tool by pouring a few drops of light lubricating oil into the air inlet on the tool

If there is no pressure regulator, bleed the airline to clear it of accumulated dirt or water before
connecting the air hose to the tool. If there is a filter, drain it.

Check for proper nose piece which is dependent on the size of the rivet.

Remove the nose piece from the front nose assembly and inspect for cracks, wear or other
damage. Replace if necessary.

Check that front nose assembly is fully tightened onto body
1.
Clean the 3-piece Jaw from the nosepiece side.
Using the air gun is dangerous, and protective glasses should always be worn.
Remove the nosepiece using the spanner set supplied, and remove any metal filings
from around the jaw using the air gun. Use a rag to prevent the metal filings from
flying around. Check the amount of dirt while doing this and, if necessary, remove the
jaw and clean it.
2. Using the spanner supplied, remove the nosepiece.
Attach a maintenance tube to the tip of the
Screwdrivers supplied, and remove the slide guide.
(Drawing 1)