4
AIR SUPPLY
The rivet tool is powered by compressed air at an optimum pressure of 5.5 bar (80 psi)
The use of a pressure regulator filter/lubricator unit within 3 meters of the tool is highly
recommended to extend the life of the tool.
Dirt and/or water in the air supply can seriously impact the performance and durability of
the tool; damage to the tool caused by contaminated air supply is not covered under
warranty
OPERATION
1
1
1
.
..
Inspect for damage
2
2
2
.
..
Connect the tool to the air supply
3
3
3
.
..
Always bleed air line to clear it of all accumulated dirt or water before connecting air supply
to tool
.
4
44
.
..
Air supply of 80-90 P.S.I must be available.
5
5
5
.
..
Choose and securely install the applicable nose piece for the rivets you wish to apply. A ¼”
flat face nose piece is installed as standard
6
6
6
.
..
Bring the tool and the rivet into the application hole. Insure the rivet head flat onto surface
7
7
7
.
..
Fully actuate the trigger. The tool will cycle and set the rivet while ejecting the nail into the
rear mandrel catcher.
8
8
8
.
..
Empty catcher when at 50% capacity
Summary of Contents for RK-250
Page 8: ...8 SCHEMATIC ...
Page 9: ...9 Part List ...