WWW.RSIWW.COM
33 of 40
8.4f
Hold two profiles together in place at ridge using one
B-4 connector. Insert two T-bolt assemblies, line up
center hole with long hex bolt in roof ridge. Secure
T-bolt assemblies
as shown.Place
washer on long
bolt and secure
with S-2C cap.
F-1
F-1
R-1
B-4
From inside, hold profile in place with
one B-4 connector. Secure with two
T-bolt assemblies as shown.
8.4e
F-1
B-4
F-1
NOTE: VIEWS FROM INSIDE.
8.4D
NOTE: VIEW FROM OUTSIDE.
NOTE: Use dish soap with water
on edges of panels to help slide
F-1 profile into place.
From the inside, have one person lift the bottom
corners of the two panels where they meet.
From the outside have the other person hold
and position F-1 profile so both
panels fit in channels on sides
of F-1 profile. Slide the F-1
profile up towards the roof ridge.
As the profile moves up, have the
person on the inside guide it into place.
F-1
B-4
S-5B
1
S-2C
4
S-2D
1
2
Connector
QTY
Connector
QTY
S-7
4
F-1
W-1
W-1
F-1
W-1
W-1
F-1
W-1
W-1
F-1
W-1
W-1
8.7A
Remove plastic film from both sides of
one W-2 panel. It will be installed opposite
the W-1 panel installed in 8.5C. From
outside position panel with extended
ledge profile at outside top. Install
panel at slight angle sliding all the
way into F-1 profile. Fit other end
into opposite F-1 profile. When
necessary, loosen B-4 connector
holding F-1 profiles at sides to
move each profile away from
opening to create space to
slide W-2 panel into channels.
NOTE: Return all parts to previous
position when finished.
NOTE: VIEWS FROM OUTSIDE.
W-2
1
Panel
QTY
24” x 32
¼”
F-1
F-1
F-7
W-1
W-2
