WWW.RSIWW.COM
33 of 45
R-1
F-7
W-1
G-1
F-7
W-1
R-1
F-7
G-1
W-1
NOTE: VIEWS FROM OUTSIDE.
NOTE: VIEWS FROM OUTSIDE.
Working from back right corner, remove plastic film from both sides of one
W-1 panel. With side marked “ UV Resistant” facing outside, fit top end of
panel into channel in R-1 roof ridge near corner. Push panel into roof ridge
channel until the other end rests on gutter ledge and then slide towards
F-7 corner profile. Repeat to install W-1 panel in back left corner.
Fit one F-1 profile next to right panel. F-1 profile rests against widest part of roof
ridge and lines up with top of gutter.
Hold two profiles together at ridge using one B-4 connector. Secure with two T-bolt assembies .
From inside, hold profile in
place with one B-4 connector.
Secure with two T-bolt
assemblies as shown.
8.2A
8.2B
Repeat step 8.2B through 8.2C to secure install and secure F-1 profile on left side.
8.2D
8.2e
8.2c
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
R-1
F-1
W-1
G-1
F-1
G-1
W-1
R-1
F-1
W-1
F-1
B-4
F-1
R-1
F-1
F-1
B-4
B-4
S-2C
6
3
Connector
QTY
W-1
2
Panel
QTY
24” x 57”
Connector
QTY
S-7
6
R-1
F-7
G-1
W-1
W-1
