W-1
W-1
F-7
spacer tool
F-8
3.1D
Remove plastic film and fit the W-1 panel into
channel in base and F-8 profile. Position F-1
profile so that panel fits into channel in F-1
profile and slide F-1 profile against spacer to
ensure proper placement.
Repeat step 3.1C to secure.
WWW.RSIWW.COM
16 of 45
Assemble Back Wall
CHECK YOUR WEATHER FORECAST. DO NOT CONTINUE ASSEMBLY DURING WINDS.
Make certain the pieces are in the correct positions before securing.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
WARNING: The cut edge of F-8 profile is
sharp. Use extreme caution when handling.
QTY
Profile
F-1
1
F-8
1
56”
72”
QTY
Connector
B-3
S-2C
S-7
2
4
2
Panels
QTY
W-1
2
24” x 57”
3.1A
Working from inside, remove plastic film from both sides of one W-1
panel. Fit panel into channel in base and corner profile, placing side
marked “ UV Resistant” facing outside.
3.1B
Position F-8 profile so the cut edge is angled
down toward the right when installed. Place
23 1/8 inch spacer on base next to F-7
corner profile. Fit panel into channel in right
F-8 profile. Slide F-8 profile against spacer
to ensure proper placement.
IMPORTANT: The panels expand and contract depending on the temperature.
To ensure proper placement, use the 23 1/8 inch spacer included with the tools.
3.1c
Use B-3 connector with T-bolt assemblies as shown to secure to base.
NOTE: Position F-8 profile so cut edge is angled
down towards nearest corner when installed.
NOTE: ALL VIEWS FROM INSIDE.
NOTE: VIEW FROM INSIDE.
B-3
F-8
spacer tool
W-1
F-1
F-8
