Steelhead Appliance Installation and Configuration Guide
59
Configuring In-Path Steelhead Appliances
Installing and Configuring the Steelhead Appliance
Step 8: Admin password?
Riverbed strongly recommends that
you change the default administrator
password at this time. The password
must be a minimum of 6 characters.
The default administrator password is
password
.
Step 8:
Admin password? xxxyyy
Step 9: SMTP server?
Enter the SMTP server. External DNS
and external access for SMTP traffic is
required for email notification of
events and failures to function.
IMPORTANT
: Make sure you
provide a valid SMTP server to ensure
email notifications for events and
failures.
Step 9:
SMTP server? natoma
Step 10: Notification email
address?
Enter a valid email address to receive
email notification of events and
failures.
Step 10:
Notification email
address? [email protected]
Step 11: Set the primary interface
speed?
Enter the speed on the primary
interface (that is, the Steelhead
appliance). Make sure this value
matches the settings on your router or
switch.
The default value is auto.
Step 11:
Set the primary interface
speed? [auto] auto
Step 12: Set the primary interface
duplex?
Enter the duplex mode on the primary
interface. Make sure this value
matches the settings on your router or
switch. The default value is auto.
Step 12:
Set the primary interface
duplex? [auto] auto
Step 13: Would you like to
activate the in-path
configuration?
Enter yes at the system prompt to
configure in-path support. An in-path
configuration is a configuration in
which the Steelhead appliance is in
the direct path of the client and server.
For detailed information about in-
path configurations, see the Steelhead
Appliance Deployment Guide.
Step 13:
Would you like to
activate the in-path
configuration? yes
Step 14: In-Path IP address?
Enter the in-path IP address for the
Steelhead appliance.
Step 14:
In-Path IP address?
10.11.11.6
Step 15: In-Path Netmask?
Enter the in-path netmask address.
Step 15:
In-Path Netmask?
255.255.0.0
Step 16: In-Path Default
gateway?
Enter the in-path default gateway (the
WAN gateway).
Step 16:
In-Path Default Gateway?
10.11.11.16
Step 17: Set the in-path: LAN
interface speed?
Enter the in-path, LAN interface
speed. Make sure this value matches
the settings on your router or switch.
The default value is auto.
Step 17:
Set the in-path: LAN
interface speed? [auto] auto
Step 18: Set the in-path: LAN
interface duplex?
Enter the in-path, LAN duplex. Make
sure this value matches the settings on
your router or switch.
The default value is auto.
Step 18:
Set the in-path: LAN
interface duplex? [auto] auto
Wizard Prompt
Description
Example
