SteelConnect Gateway Hardware Installation Guide (SDI-130, SDI-330, SDI-1030)
17
Powering the gateways
Installing the SteelConnect Gateways
4.
Insert the appliance into the rack and line the screws up to the rails so that you can insert the screws
and slide the appliance into the rack.
Figure 2-7. Installing the appliance into the rack
5.
Use screws to secure the front of the appliance to the rack. Then tighten the screws along the back
of the appliance to secure the rail to it. This secures the rear of the appliance to the rack.
Figure 2-8. Securing the appliance to the rack
Powering the gateways
Caution:
In European electrical environments you must ground (earth) the Green/Yellow tab on the power cord to
avoid electrical shock.
1.
If your system has a master power switch, ensure that the master power switch is in the off position
on the rear of the appliance.