NIC Status Lights for xx60, xx55, and xx50 Appliances | 163
NICs for Series xx50 platforms
Two-Port FX Multimode Fiber 100-Mbps PCIe card
This section describes the Two-Port FX Multimode Fiber 100-Mbps PCIe card (410-00107-01) status
lights.
Note:
The Two-Port FX Multimode Fiber 100-Mbps PCIe card requires RiOS software 5.5.9, 6.0.4 or later.
Figure C-27. Two-Port FX Multimode Fiber 100 Mbps PCIe
The interface names for the NICs in the SteelHead Management Console and the CLI are a combination
of the slot number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port
NIC is located in slot 1 of your system, the interface names are lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
The following table describes the Two-Port FX Multimode Fiber 100 Mbps PCIe card status and LED
lights.
Note:
In a 1U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from left to right.
Note:
In a 3U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from bottom to
top.
LED
Condition
Link
GB = Yellow
100 MB = Green
Activity
Blinks green on activity.
Bypass/Fail-to-Block (disconnect)
Solid green in bypass mode. Solid yellow in
disconnect mode.