![background image](http://html.mh-extra.com/html/riverbed/steelcentral-appresponse-2170/steelcentral-appresponse-2170_installation-manual_1465708149.webp)
NIC Status Lights for xx60, xx55, and xx50 Appliances | 149
NICs for SteelHead CX, DX, EX, SteelFusion, and SteelCentral platforms
The interface names for the NICs in the SteelHead Management Console and the CLI are a combination
of the slot number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port
NIC is located in slot 1 of your system, the interface names are lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
Note:
In a 1U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from left to right.
In a 3U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from bottom to top.
The following table describes the Two-Port SR Multimode Fiber 10-GbE card status and LED lights.Two-
Port SX Multimode Fiber Gigabit Ethernet card
This section describes the Two-Port SX Multimode Fiber GbE PCIe card (410-00101-01) status lights.
Figure C-8. Two-Port SX Multimode Fiber GbE PCIe
The interface names for the NICs in the SteelHead Management Console and the CLI are a combination
of the slot number and the port pairs (lan<slot>_<pair>, wan<slot>_<pair>). For example, if a four-port
NIC is located in slot 1 of your system, the interface names are lan1_0, wan1_0, lan1_1, and wan1_1
respectively.
Note:
In a 1U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from left to right.
In a 3U appliance the LAN and WAN ports are numbered in ascending order (such as 0, 1, 2) from bottom to top.
The following table describes the Two-Port SX Multimode Fiber GbE PCIe card status and LED lights.
LED
Condition
Link
Solid green on link.
Activity
Blinks green on activity.
Bypass/Fail-to-Block (disconnect)
Solid green in bypass mode. Solid yellow in
disconnect mode.
LED
Condition
Link
Solid yellow on link.
Activity
Blinks green on activity.
Bypass/Fail-to-Block (disconnect)
Solid green in bypass mode. Solid yellow in
disconnect mode.