![background image](http://html.mh-extra.com/html/riverbed/steelcentral-appresponse-2170/steelcentral-appresponse-2170_installation-manual_1465708125.webp)
Network Card Status Lights for SteelHead GX, xx70, SteelCentral, Interceptor, and SteelFusion Core | 125
Two-Port 1-GbE Fiber SX card
Two-Port 1-GbE Fiber SX card
Two types of Two-Port 1-GbE Fiber SX cards can be installed in the 1U SteelHead 3070 and the 2U
SteelHead 5070, SteelHead 7070, and Interceptor 9600 appliances.
Type 2 cards are supported on the following software versions:
•
SteelHead versions: 8.6.0, 9.0.0, 9.1.0 and 9.2.0
•
Interceptor versions: 4.5.3, 5.5.0, and 5.0.1
Note:
The physical ports on the NICs are mapped in proximity to the PCI bus edge connector. The port closest to
the edge connector is L0, then W0, L1, followed by W1.
Figure B-3. Two-Port 1-GbE Fiber SX Type 1 card (NIC-1-001G-2SX-BP)
Figure B-4. Two-Port 1-GbE Fiber SX Type 2 card (NIC-1-001G-2SX-BP)
SPD
—
1000 Mbps = Orange
100 Mbps = Green
10 Mbps = Off
BYP1, BYP0
—
Disconnect = Yellow
Bypass = Green
Normal = Off
Specification
Descriptions
Connectors
Four shielded RJ-45
Cables and operating distance
10-Base-T Category 3, 4, or 5 maximum 50 m*
100-Base-TX Category 5 maximum 50 m*
1000-Base-T Category 5E maximum 50 m*
*Theoretical distance is defined as half a distance as stated by the IEEE 802.3
standard.
Port
Description
P0, P1
TX and RX provides access to 1000 Base-SX
LED
Type 1 definitions
Type 2 definitions