CO
2
NNEXT
rev.01
EN
75 / 293
2.5.
Proper and improper use of the partly-completed machine
The partly-completed machine which is the subject of these assembly instructions has been designed and
constructed exclusively for refrigeration. The partly-completed machine is configured to use only R744 (CO2)
refrigerant gas.
The manner in which each partly-completed machine is designed to use only the above refrigerant is
specified. It is therefore important to use the partly-completed machine in compliance with the refrigerant
fluid for which it was designed and built and as received from the Manufacturer.
The partly-completed machine has been designed and built to work in environments where there is no
potentially explosive atmosphere.
The partly-completed machine must be adequately protected from atmospheric agents.
It is a good precautionary measure to have powder extinguishers in the vicinity of the partly-completed
machine. To prevent the possibility of fire, keep the partly-completed machine clean of plastic pieces, oil,
solvents, paper and rags.
Use of the partly-completed machine for different operations could cause harm to persons or damage to the
machine itself and are therefore considered improper use for which the manufacturer is not responsible.
DANGER: The user MUST view the type of gas contained in the partly-completed machine and its
quantity in order to operate properly.
ATTENTION: In case of different use, it is essential to consult in advance with the Manufacturer's
Technical Office.
DANGER: With R744 (CO2) refrigerant all operations must be carried out only by specialist technicians
trained to operate with this type of refrigerant.
2.6.
Incorporation statement
This document is accompanied by a Declaration of Incorporation which will be issued by the manufacturer at
the time of purchase.
