RITEWAY HH-8200, Operator'S Manual

Page: 10 / 84

3

Remove wrapping and wash unit, removing all road debris. (Road salt, mud, snow, etc.)

Inspect paint, decals and general appearance of unit.

Verify that the owners manual is in the manual storage tube.

Verify ‘ SLOW MOVING VEHICLE ’ sign (SMV) is on unit

Verify that jacks are with the unit and function properly.

Check wheel bolts for proper torque.

Check for proper tire pressure (PSI).

Verify that the wheel hubs are lubricated.

Verify that locking pins and / or ram locks are in place.

Lubricate all components as per operators manual recommendation.

Check that all bolts and fasteners are at the proper torque specifications.
(NOTE: All cap screws that have lock nuts joining moving pieces should not be tightened completely,
they must allow movement. i.e. Spring pressure kits, rock shaft connector, draft arm, etc.

Check sprocket alignment and chain tension. (If applicable)

Check locking collars and set screws for proper tension. (If applicable)

Verify operation of lights. (If applicable)

Verify the unit moves ‘ IN ’ and ‘ OUT ’ of transport without any binding.

Verify that tires are tracking properly when in transport mode.

Insure that all hydraulic hoses and lines are routed properly and secured.

Verify that all hydraulic fittings / hoses are secure and there are no oil leaks.

Inspect all cylinders for leakage and the cylinder shaft for rust, pits, or scratches.

Verify operation of all hydraulic functions - Cycle hydraulic cylinders to remove air from the system.

Verify that ‘ The customer is aware of warning decals and proper jack placement for transport. ’.

Verify that ‘ The customer is aware of proper operation and transportation of the unit ’.

Verify that ‘ The customer has received an operators manual ’.

Explain all maintenance and service intervals to the customer (From operators manual).

Advise the customer of grease zerk locations and maintenance schedules.

Level the unit per operators manual and instruct the customer on the proper procedures.

Verify that the center harrow section has been rotated to working position.
Pre - delivery Inspection Completed By (Sign Below) Pre - delivery Inspection Confirmed By (Sign Below)