NOTE:
Figure 2
is for doors that the motor is mounted on
the jamb side,
Figure 2A
is for doors that the
motor is mounted on the storage side.
1.
Place header in front of the opening, by locating the
factory assembled header lifting tubes bolted to the
bottom of the header.
NOTE: If bollard posts are present, and the lifting tubes
cannot be used, strap around the header tube. The
shorter support post is mounted to the header at
the side closest to the jamb. Insure that the header
is 7 1/2” above the opening at the end closest to
the jamb.
2.
Lift the header using the fork lift and bolt the support
posts to the header (posts are free to slide up & down
within the c-channel bracket) and place against the wall,
Figure 2.
3.
Plumb outside of jamb support post 9” past edge of jamb.
4.
Thru-bolt the header to the wall at the (4) top and (2)
bottom mounting angles using the 6” x 6” backer plates,
all thread rods and nuts provided,
Figure 2 or 2A.
If wall
is not solid, sleeves (not provided) must be used to
prevent wall from crushing and sagging of the header.
5.
Plumb and fasten the support posts to the wall in the
(4 or 6 based on O.D.H) locations provided with the 6” x 6”
backer plates, all thread rods and nuts provided,
Figure 2 or 2A.
6.
After header and support posts have been installed,
remove the header lifting tubes and hardware.
BARRIER
®
GLIDER Single Slide Model 7100
4
PUB. NO. 7100SSG FEBRUARY 2008
HEADER INSTALLATION
FIGURE 2 - JAMB SIDE DRIVE
Panel Trolleys
Panel Stud
Holes
Close Limit Switch
Open Limit Switch
Header
Jamb Side
Shorter
Support Post
Support Post
Header Mounting
Support Post Wall
Mounting (4-6 Places)
Header Mounting Angle
(6 Places)
CL
Lifting Tubes, Make
Sure to Clamp or Tie to
Fork Lift and Remove
After Complete
9”
It is HIGHLY recommended to thru-bolt the header
with the all threaded rods provided, as this is the
main support for the door.
I M P O R TA N T ! ! !
7 1/2”
