3/4" Valve Cable
Heater Setup
I.
Valve Assembly for OmniMaster 8 –
1.
Install standpipe into hole in trough. Rubber washer
is to be on inside of trough. Tighten nut hand tight
to allow for adjustment after valve assembly is
installed.
2.
Feed hose up through standpipe and attach to valve
bracket. The hose may be shortened if necessary.
Tighten the hose clamp securely to prevent leaks.
3.
The lower front peg on valve bracket should be
inserted into hole on standpipe first. Compress valve
clip to snap in opposite hole on standpipe.
4.
Remove pin from valve assembly.
5.
Install float assembly on valve assembly using
previously removed pin.
6.
Rotate standpipe in trough until center of float
aligns with center of trough. DO NOT allow float to
be too close to cover when installed as this may
hamper valve performance.
7.
Tighten standpipe nut hand tight plus one-quarter
turn. Use no joint compound for this fitting.
J.
Cable Heater
– Uncoil cable heater and loop around the
valve. Attach the remaining part of the cable heater to the water supply, as
far down the riser tube as possible with the cable twist ties provided. This
heater is water tight, but should not be immersed in water. Heater may
cross over itself, but should not be tightened at those locations.
CAUTION: Installation must not cause any strain on heater
wiring connections. Avoid heater damage caused by hot spots
due to its leads lying too close to each other. Also, do not
wrap additional insulation around heater.
K.
Electrical Connection
- The electrical installation should be made
and maintained by a qualified electrician conforming to national and local
codes. A means for disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules. For wiring connections, see
wiring diagram. Make connections according to the wiring diagram below.
WARNING: DISCONNECT POWER IF THE WATER SUPPLY IS TO BE SHUT OFF FOR AN
EXTENDED AMOUNT OF TIME. FAILURE TO TURN OFF POWER CAN RESULT IN
DAMAGE TO THE WATERING FOUNTAIN.
OmniMaster Series Instruction Manual
3
11 October, 2017
