Riso MH 9350, User Manual

Page: 85 / 218

Chapter 3 Functions for Master Making
83
3
Checking the Original Data Image
[Preview]
■
Description of the screen
■
How to display the preview
You can display the [Preview] screen in the following
situations.
Operation procedure in the [Preview]
screen
This section describes the operation procedure to
make a master from a paper original as an example.
1
Touch [Preview] in the [Functions]
tab screen.
2
Set the master making conditions.
(
A
52 “Functions for Master Making”)
(
A
108 “Useful Functions”)
3
Press the [START] key.
Scanning of the original starts.
After the original has been scanned, the [Pre-
view] screen is displayed.
You can check the scan image of the original and
the original data image that is retrieved from [Stor-
age] or [USB Job List].
B
You cannot use this function with the fol-
lowing functions.
C
[Ink Saving] (
A
58)
C
[Quick Master Making] (
A
59)
C
[Output reversal] (
A
85)
B
In dual-color mode, [Preview] is turned
[ON] automatically. However, when [Quick
Master Making] (
A
139) under [Admin.] is
[ON], [Preview] is turned [OFF].
B
[Preview] is turned [ON] automatically
when the following functions are set: How-
ever, if [Auto Preview] (
A
143) in [Admin.]
is [OFF], [Preview] is set to [OFF].
C
[Layout] (
A
73)
C
[Multi-Up Print] (
A
75)
C
[2 Up] (
A
80)
1
Touch this button to enlarge the view by one level.
2
Touch this button to reduce the view by one level.
3
Touch this button to switch between [
R
(vertical)] and
[
Q
(horizontal)] alternately.
4
Shows the current magnification rate.
5
Touch this button to change the magnification rate so
that the whole view of the original data image fits in the
display area.
6
Use these buttons to move the display position.
7
Shows the original data image.
Touch an image to move its display position so that the
touched image is displayed in the center of the screen.
8
In the case of originals for dual-color printing, the tab
buttons below are displayed. Touch the tab buttons to
switch the display screens.
[
k
+
l
]: Image that is overprinted in dual-color.
[
k
]: Image to be printed with print drum (cylinder) 1.
[
l
]: Image to be printed with print drum (cylinder) 2.
1
2
3
4
5
7 6 8
B
Even when the image is fully displayed
in the [Preview] screen, the image parts
outside the range for master making are
not printed. Check that the margins are
sufficient.
(
A
18 “Master making area”)
Situation Display method
Making a master
for a paper origi-
nal Touch [Preview] in the [Functions] tab
screen of the master making basic
screen. After scanning of an original,
the [Preview] screen is displayed.
Saving a paper
original as data Touch [Preview] in the [Functions] tab
screen of the scan basic screen. After
scanning an original, the [Preview]
screen is displayed.
Printing original
data received
from the com-
puter Touch [Preview] in the [Basic] tab
screen of the master making basic
screen for the original data.
B
[Preview] is not avail-
able when [Auto Pro-
cess] is turned on as the
operation does not stop
before master making.
Printing the
saved original
data There are the following two methods.
• Touch [Preview] in the [Storage
Retrieve] or [USB Job List] screen.
• Touch [Preview] in the [Basic] tab
screen of the master making basic
screen for the original data.