A
*
on the set End value of Output.
Pressing the “
Up” key will advance the operation to the
next digit and set the third digit, in this case to “0”.
Enter New / Change Start value of
the Output 1, third digit entered,
prompting for fourth digit. (*
denotes that digit will be flashing).
Pressing the “
Down” key will
scroll the value of the fourth digit
from 0 through to 9, the value will
wrap from 9 round to 0 depending
on the set End value of Output.
Pressing the “
Up” key will advance the operation to the
“New / Changed Start value of the Output 1” confirmation
and set the fourth digit, in this case to “0”.
New/changed Start value of the
Output 1 confirmed.
Pressing the “
Down” key will
re-enter to the “New / Change Start
value of the Output 1”.
Pressing the “
Up” key will
confirm New Start value of the
Output 1 and advance to the
selection of Elbow value of Output1(section 3.1.6.1.3) or
Output 2 characteristics setting (section 3.1.6.2)
3.1.6.1.3 Elbow value of output 1
This screen appears only when Elbow function is enabled.
This screen allows the user to set the Elbow value of
Output 1(considerd as DC Current).
The Elbow value can be set any value between set Start
value of Output and End value of Output.
26
A
Summary of Contents for RISH CON - I
