Chapter 4 BIOS Setup
R860
31
SIS OnChip PCI Device
SIS USB Controller Enabled (default), Disabled.
USB Ports Number 6 Ports (default), 5 Ports, 4 Ports, 3 Ports.
USB 2.0 Supports Enabled (default), disabled.
USB Keyboard Support Disabled (default), Enabled.
SIS AC97 AUDIO Enabled (default), Disabled.
SIS S/W Modem Disabled (default), Enabled.
SIS 10/100M ETHERNET Disabled (default), Enabled.
x
SIS MAC Address Input Press Enter
SIS 1394 Controller Enabled (default), Disabled.
LCD Panel ID Sel 1280x1024 (default), 800x600, 1024x768, 1400x1050, 1600x1200.
Onboard SuperIO Device
Onboard FDC Controller Enabled (default), Disabled.
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
3F8 / IRQ 4
Port address 3F8h, IRQ 4
2F8 / IRQ 3
Port address 2F8h, IRQ 3
3E8 / IRQ 4
Port address 3E8h, IRQ 4
2E8 / IRQ 3
Port address 2E8h, IRQ 3
Auto
BIOS assigns port address and IRQ channel automatically.
Disabled Disables
serial
port
UART Mode Select
Normal (default), IrDA, ASKIR.
This field must be configured in order to use the infrared connector, which supports infrared wireless
transmitting and receiving of data between devices when using the appropriate application software.
When setting the field to either IrDA or ASKIR, you must select the active level of receiving and transmission
signal.
RxD, TxD Active :
Hi, Lo (default) / Hi, Hi / Lo, Hi / Lo, Lo
IR Transmission Delay :
Enabled (default), Disabled.
UR2 Duplex Mode :
Half (default), Full.
Use IR Pins :
IR-Rx2Tx2 (default), RxD2, TxD2
