Setting and Unsetting
Page 20
Chapter 2
Setting and Unsetting
The following chapter describes how to operate your LightSYS2 locally from the LCD
keypad. For system operation from other accessories, refer to the instructions supplied
with the product.
As a user of your security system, you'll mostly be concerned with the keypad.
The LightSYS2 LCD keypad is the primary system interface. Each keypad in your system
reports its status via its LCD icons, as described below. Through its keys, you can enter
commands to set and unset the system, omit intrusion zones, report emergencies, and
more, as described in the subsequent chapters of this manual. For detailed information
regarding the keypad interface, refer to the instruction supplied with the keypad.
Notes:
1.
There are two types of LCD keypads, with and without proximity for non-contact
setting and unsetting.
2.
Each keypad in the system is assigned to a particular partition, meaning that
commands entered in a keypad are implemented only in the partition to which it is
assigned. For example, pressing the Quick Set key on a keypad assigned to
partition 1 sets only partition 1
Setting your system
Setting your system causes the intrusion detectors to trigger an alarm when violated. You
can set your system by code setting, in which you need to use your user code, or you can
use quick setting (without using a code).
Note
:
If during code setting you enter a wrong user code, the keypad produces
three short beeps. Simply re-enter the correct sequence.
Remember, fire protection and the protection offered by the keypad's emergency keys are
always set and always available (if authorized by your engineer).
Before setting the system:
1.
Verify that the
(ready) icon is lit or flashing indicating that system is READY
to be set.
2.
Make sure that the system includes no violated zones and is ready to be set.
3.
If the system is NOT ready to be set, secure or omit the violated zone(s) (see page
37), and then proceed.
