Page
25
GT490X
User Manual
Setting Engineer Authorisation
A User Code may be required to authorise an engineer to gain access to the system in
the event of service or maintenance schedules. The level of User Code required to
authorise the engineer to access the system is set within the User Menu that is
accessed via a Master Level Code.
Setting the Engineer Authorisation Level
1)
Enter a
Master
User Code. The display will
show:-
2)
Press NO until the display shows:-
Then press YES.
3)
Press NO until the required setting is displayed:-
Master
,
Main
and
Any
are user code levels.
If
None
is selected, no user authorisation will be required to grant engineer access to
the alarm system. However, the panel will generate an audible sound for
approximately 8 seconds to indicate that the engineer is on site.
4)
Press YES. The display will show:-
(This option is dealt with later).
5)
Press YES. The display will show:-
6)
Press 0 to return to:-
Using Engineer Authorisation
A valid Authorisor code will be required to give an engineer access to the alarm
system. This may be done in two ways.
1)
The engineer will enter his/her code. The display
will show:-
2)
Enter a valid level of User code to grant the
engineer access.
Do you want to . .
SET the System ?
Do you want to . .
Authorise Engnr ?
Engnr Authorisor
=Any
Engineer Access
is Off Ok ?
Do you want to . .
Authorise Engnr ?
01 JAN 18 : 58 : 01
Enter Authorisor
Code . . . . . .
PR5847 Rev11 490X User Guide.qxd 10/05/2012 11:01 Page 25
Summary of Contents for gt490x
Page 2: ......
Page 35: ...Page 33 GT490X User Manual Notes ...
