Page
4
GT490X
User Manual
Setting The System
1)
With the display showing:-
2)
Enter your
User
code.
(Followed by YES if a
Master
or
Main
type code
has been used). The display will show:-
and a continuous exit tone will sound.
Note:
Count down in display is dependant on the setting mode
programmed by the Engineer.
3)
Exit the premises via the authorised exit route
(the exit tone will change if any detectors are violated during exit).
4)
Once the premises are secure listen, (from outside
the protected area) that the exit tone returns to the
continuous tone.
5)
Wait until the exit tone finishes before leaving.
Note:
If enabled by the engineer, pressing the Quick key during exit time will
shorten exit time to 3 seconds.
Note:
G-Tag Proximity Tags may be used for setting and unsetting the
system. Please refer to the Using G-Tag section for instructions.
Note:
Depending on the level of your system and the legislation that it is
required to comply with your installation company may have initialised
Display Blanking. When this is used the Status of the system will only
be indicated on the display for ten seconds after it has been Set and for
ten seconds after it has been Unset.
Setting if a Zone has been put on test
If a zone has been put on test, and the system is to be Set /
Part Set / Area Set, the display will show:-
and a warning tone will sound.
If you wish to
set
the system press
NO
to continue.
Note:
If you are unaware that a zone has been put on test contact
your installation company.
01 JAN 18 : 58 : 01
EXIT Now !
All Zones ON 15
Time will count down
Zone/s On Test
NO to Continue
PR5847 Rev11 490X User Guide.qxd 10/05/2012 11:01 Page 4
Summary of Contents for gt490x
Page 2: ......
Page 35: ...Page 33 GT490X User Manual Notes ...
