Page
8
GT490X
User Manual
Removing Zones When Setting (Master & Main codes only)
If programmed by the installation company, individual zones may be removed (omitted)
when the system is set, this may only be done by a Master or Main level of code.
1)
With the display showing:-
2)
Enter a
Master
or
Main
level code,
the display will show:-
3)
Press NO, the display will show:-
4)
Press YES, the display will show:-
5)
Enter the zone number you wish to
remove followed by YES. (pressing
NO will 'un-remove' a zone). The
display will show:-
6)
Repeat step 5 until you have removed all
the required zones.
7)
Press 0 to escape, the display will show:-
8)
Press YES, the continuous exit tone will
sound.
9)
Exit the premises via the authorised
exit route ( the exit tone will change as detectors
are violated). When the premises are secure
listen that the exit tone returns to the continuous
tone. Wait until the exit tone finishes before leaving.
Note:
Zone remove is only effective for the one set.
01 JAN 18 : 58 : 01
Do you want to . .
SET the System ?
Do you want to . .
SET the System ?
Do you want to . .
REMOVE Zones ?
Enter Zone # - - -
then +Yes or -No
Enter Zone # - - -
then + YES or - NO
PR5847 Rev11 490X User Guide.qxd 10/05/2012 11:01 Page 8
Summary of Contents for gt490x
Page 2: ......
Page 35: ...Page 33 GT490X User Manual Notes ...
