5
Cut off the power at once when finishing flight to avoid overuse and influence the
battery efficiency.
Do not charge when the battery surface is hot till cooling down, or may influence
its use life.
Please use the recommended charger only.
Check the charger’s wire, plug, surface regularly. Do not use any broken charger.
Notice:
2. Power on the drone.
3. Put the drone on the flat ground, the indicator lights of the drone turn from flashing to
solid bright, which indicates successful frequency pairing. The drone is ready to be
controlled.
Calibration Instruction
Please follow the below steps to calibrate the drone if the drone can not be adjusted by trim
button and cause difficult operation.
1. Power off the drone and then turn off the transmitter power switch.
2. Turn on the transmitter switch, push the Throttle Stick all the way up then all the way
down, and the transmitter enters pairing mode.
3. Power on the drone and put it on a flat surface in a horizontal position. You will hear “di,
di, di” beeping noise three seconds later, which indicates successful code pairing. The
drone body light will turn solid.
1. Turn on the transmitter switch and its indicator lights begin to flash quickly. Push the
Throttle Stick all the way up then all the way down. The indicator lights become flash
slowly, which indicates the transmitter enters code pairing.
Frequence Pairing
LiPo Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household trash.
Please contact local environmental or waste agency or the supplier of
yourmodel or your nearest LiPo battery recycling center.
Summary of Contents for FREEDOM 3D U32
Page 1: ...U32 ...
