4
(5) Make sure the connection is solid between battery and motor etc. The ongoing vibration
may cause bad connection of power terminal make the drone out of control.
(6) Improper operation may cause drone crash, which may arouse motor defective and
noise, and then effect the flying status or even stop flying. Please go to the local
distributor to buy new parts for replacement so that the drone will return to its best status.
(4) Please strictly obey the order of turn on and turn off before operation. Turn on the
transmitter power first and then turn on the drone power before flying; turn off the drone
power first and then turn off the transmitter power when finish flying. Improper turn on
and turn off order may cause the drone out of control and threaten people’s safety.
Please cultivate a correct habit of turn on and turn off.
(1) Flying field must spacious enough and we suggest at least
8M (length)*8M (width)*5M (height).
(2) Make sure the battery of the drone and its transmitter are fully charged.
(3) Make sure the Throttle Control Stick of the transmitter in the lowest position.
3. Check List Before Flight
Transmitter Installation:
Battery installation:
open the battery cover on the back side of the transmitter and put 4
alkaline batteries (not included) into the box in accordance with
electrode instructions.
+
-
+
-
-
+
-
+
Battery Cover
4*1.5V
Alkaline Batteries
1. Make sure the electrodes are correct.
2. Do not mixed use new and old batteries.
3. Do not mixed use different kinds of batteries.
4. Do not charge the non rechargeable battery.
Notice:
* Do not use the battery to crash or hit hard surface.
* Do not put the battery in water and keep it in dry place.
* Do not open the battery.
* Do not leave the battery without supervision when charging.
* Make sure that there is no short circuit of the power wire.
Charging Instruction
1. Connect the drone battery with USB charger first and then choose one of the below
methods to connect with USB charger. (prior to choose 2A, 5V charger)
2. The red USB indicator light keeps bright when charging.
3. The charging time is about 50 minutes. The light turns to green when fully charged.
4. Li-Po battery is included in spare parts and please pay attention on below safe notice.
* Do not put the battery on high temperature place, such as fire or heating device to avoid
damage or explode.
Summary of Contents for FREEDOM 3D U32
Page 1: ...U32 ...
