Rinnai 14
SS850 Freestanding IM
FREESTANDER INSTALLATION
Unpack the fire.
1. Remove the frame (two screws).
Ⓐ
2. Remove the control panel (two screws) and unplug the
ON/OFF switch.
Ⓑ
Prepare location of gas and power.
1.
Mark the position of the flue centreline on the floor.
Note the minimum distance from the wall (50 mm).
2.
The gas and power supply can be brought in through the base of the fire. The pipe/power cord must enter
within the shaded area shown on page 12. The hole must not extend beyond the fire footprint. If the power
is to be brought in from the back, there is a knockout in the bottom right corner (viewed from the back of the
fire) of the back panel that can be removed with pliers. There is also a knockout for the gas on the back panel.
Check the flue configuration.
Check the flue configuration. Check if the aeration plates need adjusting or additional plates that may need to be
added. Refer to page 15 for more information.
Reassemble and secure.
Follow the reverse steps for unpacking the fire. Secure the fire to floor using mounting holes
Ⓒ
Install flue system.
Install coaxial flue system. Refer to pages 24 through 29.
Complete gas connection.
Install gas connection. Refer page 11.
Install the burn media and commission.
Install the burn media, refer page 22. Refit the glass and the inner and outer frames.
A
A
C
C
B
B
INSTALLATION
