Rinnai
8
Operation Manual
BASIC HEATER OPERATION
TURNING ON THE POWER
To reset the heater, press the On/Off
button once. Press the STANDBY/ON
button a second
time to switch the heater on.
USING THE REMOTE CONTROL TO OPERATE THE HEATER
Press the On/Off
button located on the heater control panel once. The
Operation Indicator
will illuminate and glow ‘Red’ and the ignition process
will commence.
The heater will continue to operate in the automatic mode to achieve and
maintain a default temperature setting of 22°C until an alternate command is
received from the remote control.
If the main power is disrupted whilst the heater is operating, once the power
is restored the heater will go into power failure mode. This is indicated by a
pair of flashing zeros in the Error Display
window and a ‘Green’ flashing
Operation Indicator
.
To operate the heater in automatic mode without using the remote control, press
the main power switch on the heater off and then on again. The heater will operate
with a default set temperature of 22°C.
If the heater is turned off using the On/Off
button on the heater control panel
when it is turned back on it will loose all timer and clock settings until the remote
control is used to re-transmit this information.
DO NOT unplug the main power supply, to extinguish the flames as this may cause
damage. The convection fan is required to continue operation for several minutes
after extinction of the flames to assist cooling.
Turning The Heater On
When the heater is in standby mode (Operation Indicator
illuminated
‘Green’) pressing the STANDBY/ON
button will start the ignition
sequence and the Operation Indicator
will glow ‘Red’ to indicate that the
heater is now in operation.
Turning The Heater To Stand-By
Press the STANDBY/ON
button. This will extinguish all flames and the
Operation Indicator
will glow ‘Green’ to indicate the appliance is now in
stand-by mode.
ADJUSTING THE TEMPERATURE
When in automatic mode, pressing the Up and Down
buttons will change
the pre-set temperature by increments of 1°C with each press.
"Temperature"
will be displayed to confirm that the function has been
initiated. The Remote Display will show the selected temperature
in
degrees °C .
The temperature can be pre-set to:
A.
L (Low)
– Continuous combustion on low.
B.
16°C ~ 26°C (in 1°C steps)
– Thermostatic control to pre-set temperature
selected. Combustion rate varies to maintain the selected temperature.
C.
H (High)
– Continuous combustion on high.
7
8
7
8
9
10
10
8
8
10
7
11
NOTE
CAUTION
8
11
8
11
8
STANDBY
ON
Flame
Extra
Low
Lock
Timer 2
Timer 1
Overide
Time
Set
Temperature
Lock
Clock
AM
PM
Timer 1
Set
Set
ON OFF
ON OFF
Timer 2 Set
OverrideAuto Off
Time
Flame
20
21
14
15
16
17
19
18
11
13
12
Temperature
Lock
AM
PM
Timer 1 Set
ON OFF
ON OFF
Timer 2 Set
Override Auto Off
23
24
12
24
23
