Rinnai
25
RHFE 952_1252 OIM
HEATER INSTALLATION
A. Installation of Ceramic Log Set (RHFE-952ER)
Before placing any burner media into the burner
box, check to ensure that the ports of the main
burner are clean and clear of any particles and all
packaging material.
For clarity the drawings are displayed without
showing the entire heater.
DO NOT remove the burner from heater engine to
install the log set.
Use extreme care when handling the Log Set components, as they are made from a very fragile
high temperature material and will damage if handled roughly, only remove the components from
their packaging as required.
The log set (A.) or stones (B.) MUST BE installed in the positions as stated.
1. Logs
&
have a pair of pin holes in their bases,
log
has an additional location pin on its top. Fit
these logs to the back of the burner box as shown.
2. Logs
,
&
each have both a pin hole and a
slot in their base and are dimensioned as to only fit
in a specific location. Fit these logs to the front of the
burner box as shown.
3. Log
has both a pin hole and a slot in its base and
a location pin at one end on its top. Fit the log to front
of the burner box and onto the pin of log
as
shown.
4. Log
has both a pin hole and a slot in its base and
a location pin midway on its top. Fit the log to front of
the burner box and onto the pin of log
as shown.
5. Log
only has a pin hole in one end of its base. Fit
the log to slot in the middle of the burner box and
onto the pin of log
as shown.
6.
Confirm the correct location of all the logs before
proceeding with the placement of the granular
burner medium.
IMPORTANT
1
2
1
3
4
5
6
1
7
6
8
7
